Flat roof felt for Charlton back additions
Behind a great many terraces in Charlton, Woolwich and Plumstead there is a flat roof: over a kitchen pushed out at the back, or a bathroom built on top of the back addition. Felt does not last for ever, and the day comes when it is stripped and done again. This guide covers what the shop lists for that job and how to count it.
Charlton Builders Merchants is the Charlton and Woolwich delivery site of Discount Builders Merchants (KENT) LTD, the builders' merchant at Lower Road, Northfleet, DA11 9BB. There is one yard, and orders are placed on www.discountbm.co.uk.

What the roofing aisle lists
There are two torch-on felts, an underlay and a green mineral cap sheet, each in a roll of 1 m by 8 m. There is a bonding underlay felt in a 20 m roll and a heavier green mineral felt in a 10 m roll. Lead for the flashing against the house wall is listed in Code 3 and Code 4. Capping boards 9 mm thick and 5 m long, from 150 mm to 300 mm wide, cover an old fascia.
For the deck there is OSB at 18 mm in the timber aisle, and furrings, the tapered lengths that give a flat roof its fall.
Layers, and who lays them
A felt roof is built up in layers: an underlay bonded or fixed to the deck, then a mineral-faced cap sheet over it. How many layers, and how each is fixed, is for the roofer and the felt maker to say. Torch-on felt is laid with a gas torch against a timber roof, which is work for a roofer who does it every week and is insured for it, not for a first attempt.
Counting the felt
Measure the roof, then add the upstand where the felt turns up the house wall and the drop into the gutter. Every run overlaps the next along its side and at its end, so a roll covers less than the 8 square metres on its label; the maker's sheet gives the lap. A roof of 12 square metres takes two rolls of each layer, not one and a half.
The deck and the fall
Strip the old felt and look at the boards before ordering more than felt. Water standing on the old roof means the fall was wrong or the deck has sagged. A deck sheet of 2440 x 1220 mm covers 2.98 square metres; divide the area by that and add about a tenth for cuts. Furrings go one to a joist, thick end at the house, and the list has them tapering from 75 mm over 3.6 m and from 100 mm over 4.8 m. The fall itself comes from the design.
The wall, the edges and building control
Where the roof meets the house, the felt turns up the wall and a lead cover flashing is dressed down over it from a joint in the brickwork. Code 4 is the usual weight for that. Measure the wall and allow for the laps between pieces. At the open edges the felt is dressed over a drip into the gutter, or up a kerb.
Stripping and re-covering a roof over a heated room can bring insulation into the job. Ask the Royal Borough of Greenwich's building control before the old felt comes off, since the answer changes the height of the finished roof and the flashing with it.
Getting it to the back of a terrace
The roof is at the back and the delivery is at the front. A roll of felt is heavy for its size and a deck sheet is 2.4 m long, and in most terraces both go through the house unless there is a rear alley. Tell the yard where the load can be set down at the front, and whether the street has controlled parking. Keep felt rolls standing on end, and the boards flat and dry, until the roofer is ready.
Rules of thumb
| Torch-on felt | Each roll is 1 m x 8 m, 8 square metres before laps. Count the underlay and the cap sheet separately. |
|---|---|
| Other felts | Bonding underlay in a roll of 1 m x 20 m. The 32 kg green mineral felt in a roll of 1 m x 10 m. |
| Deck sheets | A 2440 x 1220 mm sheet covers 2.98 square metres. Add about a tenth for cuts. |
| Furrings | One per joist. Listed tapering from 75 mm over 3.6 m and from 100 mm over 4.8 m. The fall comes from the design. |
| Lead flashing | Code 4, listed from 150 mm to 450 mm wide. The length of the wall, plus laps. |
| Capping board | 5 m lengths, 9 mm thick, from 150 mm to 300 mm wide. |
The shop has calculators that turn a measurement into a quantity.
Worked order: Re-decking and re-felting a 4 x 3 metre flat roof in Charlton
| Product | Quantity | What it is for | Cost |
|---|---|---|---|
| OSB board 2440x1220x18mm | 5 at £22.99 | New deck of 12 m2: 4 sheets at 2.98 m2, plus a tenth | £114.95 |
| 75mm - 0mm Furrings 3.6mtr | 11 at £7.62 | One to each joist: joists at 400 mm centres along the 4 m are ten spaces, so eleven. Cut to the 3 m span | £83.82 |
| SBS Torch On Underlay Felt 1mtrx8mtr (8M2) | 2 at £44.99 | 12 m2 of roof, the upstand at the house wall and the laps come to more than one 8 m2 roll | £89.98 |
| SBS Torch On Green Mineral Felt 1mtrx8mtr (8M2) | 2 at £42.99 | Cap sheet over the same area, counted the same way | £85.98 |
| 3m (150mm) Code 4 Lead 6" | 2 at £35.91 | Cover flashing along the 4 m house wall, with the laps | £71.82 |
| 200mmX5m 9mm CAPPING BOARD | 3 at £20.99 | Capping the old fascia on the three open sides: 3 m, 4 m and 3 m is 10 m, so a third 5 m board covers the cuts at the corners | £62.97 |
| Goods | £509.52 | ||
| Delivery to SE7 | £0.00 | ||
| Delivered total ex VAT | £509.52 | ||
| Delivered total inc VAT | £611.42 | ||
Not in this order: Insulation if building control asks for it, batten for the drips and kerbs, nails and primer for the felt, which the lists do not show, and the gutter.
The quantities are a starting point for a job of this size. Put the same goods in a basket on www.discountbm.co.uk with your own postcode to see the figure for your order, or send the yard your list.
On the shop today
The products this guide talks about, from the shop's Roofing aisle. Prices last checked .
-
SBS Torch On Underlay Felt 1mtrx8mtr (8M2)
m²
£53.99 inc VAT
£44.99 ex VAT
In the yard
-
3B Bonding Underlay Felt 1Mtrx20Mtr (20M2)
m²
£59.99 inc VAT
£49.99 ex VAT
In the yard
-
32KG Green Mineral Felt 1Mtrx10mtr (10M2)
m²
£51.59 inc VAT
£42.99 ex VAT
In the yard
-
3m (150mm) Code 4 Lead 6"
each
£43.09 inc VAT
£35.91 ex VAT
Low
-
3m (300mm) Code 4 Lead 12"
each
£86.18 inc VAT
£71.82 ex VAT
Low
-
75mm - 0mm Furrings 3.6mtr
each
£9.14 inc VAT
£7.62 ex VAT
In the yard
-
150mmX5m 9mm CAPPING BOARD
each
£22.79 inc VAT
£18.99 ex VAT
In the yard
-
BLACK JACK FLASH TRADE 10M x 150mm
each
£20.40 inc VAT
£17.00 ex VAT
Low
Prices are the shop's prices today. Stock and ordering are on www.discountbm.co.uk.
Roofing felt and lead delivered in Charlton See all Roofing on the shop
Delivery to Charlton and Woolwich
- SE7
-
Free when the goods reach £41.66 ex VAT (£49.99 inc VAT).
A smaller order pays the difference up to that amount: goods of £25.00 ex VAT (£30.00 inc VAT) pay £16.66 ex VAT (£19.99 inc VAT) for delivery.
- SE18
-
£250.00 ex VAT (£300.00 inc VAT) when the goods are under £500.00 ex VAT (£600.00 inc VAT).
£75.00 ex VAT (£90.00 inc VAT) when the goods reach £500.00 ex VAT (£600.00 inc VAT).
Free when the goods reach £1,000.00 ex VAT (£1,200.00 inc VAT).
More guides for Charlton and Woolwich
- Metal stud and sound insulation in Woolwich Metal track, studs, acoustic roll and soundblock board for partitions and party-wall linings in Woolwich, Plumstead and Charlton flats and terraces.
- Timber ground floors for Charlton terraces Joists, floor boards, insulation and air bricks for repairing a suspended timber ground floor in a Charlton, Woolwich or Plumstead terrace.
- One delivery for a whole job in Woolwich Why an order for Woolwich, Plumstead or Shooters Hill is best sent complete, with a whole garden wall in yellow stock brick worked through as one order.